I have a desktop with Win2000NT. I couldn't access the internet so I tried re-installing Win2000 and now I can't even boot up. I get the message: STOP: c0000263 {Driver Entry point not found} The \Systemroot\system32\drivers\FLTMGR.SYS device driver could not locate the entry point IoGetDeviceAttachmentBaseRef in driver ntoskrnl.exe. I have no idea what to do. I would be OK installing winxp on this computer but I don't know how to get past the blue screen with the msg above.
You should be able to just boot your XP CD and Clean Install XP with no issue.
If that fails or is not your first preference then what type of 2K disk are you using?
Was it the original restore/install CD? What is the make and model of the computer?
The computer is an OEM pc clone. It has an AMD 2Mghtz chip but everything else is not from any particular manufacturer. I've been using this computer since 2000 with multiple updates. My original Win2K disk doesn't have all the updates so I used what I thought was a win2k-sp4 with IE6.0 on it. But it apparently wasn't. My problem now is I can't even get to the Safe mode screen. When I push F-8 the screen just flies by and gets me to the blue screen. I've tried several different times and can't seem to get anywhere else other than the blue screen. If I could get to the BIOS at least I could make sure the boot-up order is CDRW/DVD drive first. Then the computer should see my XP disk and boot from there. But I can't get to the BIOS. The last time I was in the BIOS it did say the CDRW was the first to boot from. But it doesn't see the XP disc. So I don't know what's going on.
Try booting your original W2K disc. If that works then the W2K+SP4 disc you have is no good or not bootable.
You can create a new one slip streamed with SP4 using nLite on any Windows computer, or install with the original then apply SP4 and updates.
As for getting into BIOS, pressing F1, F2, F10 or Del will usually get you there, you just need to time it right. If all else fails, you could power the computer off and unplug the power cord. Open it and remove the CMOS battery then press and Hold the power button in for 10 seconds or so to drain any latent power from capacitors. Wait a bit, say 10 minutes or so, then put the CMOS battery back in, hook up the power cord and turn it on.
That should give you a CMOS checksum error and you should be offered the chance to press Esc to continue or F2/F2 to enter Setup.
Ztrucker - Well I've tried to do all the things you mentioned above but to no avail. I can not get this machine to do anything other than go to the blue with the original message that I said: STOP: c0000263 {Driver Entry point not found} The \Systemroot\system32\drivers\FLTMGR.SYS device driver could not locate the entry point IoGetDeviceAttachmentBaseRef in driver ntoskrnl.exe. I don't know what else to do besides kick it. Real hard.
I was able to find the CMOS battery. I broke something getting it out of the black plastic holder that secured it to the motherboard. It's back in but won't stay in if I turn (re-orient) the computer. I have now gotten to the BIOS screen which I couldn't get to before. I don't know what to do from there. There are many options that I can arrow down to. What's next?
You said you wanted to get into BIOS so you could check the bot order, make sure the optical drive is first. Look for a Boot tab or Boot Priority selection in one of the tabs.
Still having this problem?
This topic is from the What the Tech archive and can't take new replies. Geeks to Go is an active, free help community run by volunteers. Post your question there and a person, not a bot, will work through it with you.